Today I found myself with the pleasant surprise, finally SJJ has released the update of its EDK with a great novelty… Ethernet support!!! for this we will have to update the internal image. Very well prepared, it presents us with a file called “EDK_Firmware Update.pdf” in the update file itself.

Download

To have a MAC, you must send an email to [email protected] with the serial number that is written on the bottom of the board, in a few hours they will send you the update package with your personalized MAC.

Here I leave you with everything that can be played:

2 RS-232 serial ports COM1 only for Development
Internal Real time clock/calendar (no battery backup) Supported
16 processor GPIO lines Supported
16 PLD output lines - 8 lines are for high drive output lines Supported
16 PLD 5 volt tolerant input lines Supported
SPI/I2S SPI-only
Green status LED Supported
Internal flash data storage Supported
Battery backed RTC N/A
1 + 2 PWM I/O lines Available in v2.5 Update
5 channels of 12 bit A/D (0 to 3.3V) Available in v2.5 Update
1 10/100 BaseT Ethernet port Available in V2.5_Eth Update
MMC/SD hot-swap socket Support available from DotVision.com
2 USB 2.0 host ports